Highlights
- ORIGINAL INVISIBLE DISC HANGER: One large 140mm adhesive plate hanger that remains concealed behind the displayed item, leaving no visible clips, springs or wires around the edge.
- FOR ITEMS UP TO 3KG: Suitable for compatible extra-large porcelain, china, earthenware and glass plates or plaques weighing no more than 3kg.
- WATER-ACTIVATED ADHESIVE: Mix a little water into the glue, wait 5–10 minutes until tacky, press firmly into position and leave overnight before testing the ring and hanging.
Description
Display extra-large decorative plates and plaques with a clean, discreet finish using the Original Invisible Disc Plate Hanger.This 140mm disc attaches directly to the back of the item and remains concealed once displayed. It provides a neat alternative to visible clips, springs and wires around the outside of the plate. The hidden design also allows the displayed item to sit closely against the wall.The 140mm disc is suitable for compatible decorative plates, plaques and wall decorations weighing up to 3kg. It is ideal for extra-large wall plates, display plates, keepsake plates, craft plaques and other suitable indoor decorative items.The hanger can be used on properly prepared porcelain, china, earthenware and glass plates and plaques. It also provides adhesion to suitable wood, hardboard and blockboard surfaces, making it useful for compatible pictures, craft projects and decorative signs.The adhesive requires water for activation. Clean the back of the item thoroughly, mix a little water into the glue and wait approximately 5–10 minutes until it becomes tacky. Position the ring correctly, press the disc firmly against the surface and rub well to remove trapped air.Leave the hanger to dry overnight. Before hanging, test the strength of the adhesion by pulling firmly on the metal ring. A separate wall hook or wall fixing is required.How to Apply1. Clean the back of the plate thoroughly, even if the plate is new.2. Rub in a small amount of suitable scouring cream or powder.3. Rinse the surface clean and allow it to dry completely.4. Mix a little water into the glue on the disc using your fingers.5. Wait approximately 5–10 minutes until the glue becomes tacky.6. Position the disc with the ring correctly aligned for the plate design.7. Press firmly and rub well to remove trapped air.8. Leave overnight to dry completely.9. Pull firmly on the ring to test the adhesion before hanging.10. Hang from a suitable wall hook or wall fixing.Removal InstructionsFor items that can safely be soaked, place the plate in warm water until the adhesive softens. Carefully remove the disc without forcing or scraping the plate surface.Important Hanging GuidanceThe 140mm disc is intended for compatible decorative items weighing no more than 3kg. The item must provide enough suitable surface area for the complete disc to make firm, flat contact.The back of the item must be clean, dry and suitable for adhesive attachment. Do not use on damp, greasy, loose, flaking, sharply curved or unsuitable textured surfaces.Allow the adhesive to dry fully overnight and perform a firm pull test before hanging. Avoid outdoor use and locations with high humidity.A wall hook, nail or wall fixing is not included. Select a fixing suitable for the wall construction and the full weight of the displayed item.